Chamberlain Elite EL25 Quick Start Manual page 6

Programming
Description of Task
Number
Configure "Strikes and Out" Alarm
104
Feature
Enable or Disable Anti-Passback
105
Forgiveness at Midnight
Override Telephone Company
109
Answering Service
Set a Phone Number's Extension Delay
110
Time
111
Verify Multi-Unit Number
Dial "0-9" First to Get an Outside Line
113
Using a Automated Phone System
115
Set Alternative Prefixes
116
Change the Visitor Call Response Keys
120
Talk through the EL25 Speaker
121
Cycle Door
122
Latch Door "Open" Until...
123
Latch Door "Closed" Until...
124
Release Door "Now"
131
Cycle Relay "Now"
201
Delete ALL
202
Delete ALL
203
Delete ALL
204
Delete ALL
205
Delete ALL
206
Delete ALL
Press
***
Exiting programming mode allows changes to take effect
The Pound Key (#) must be used as Data Field Separator and to Save Data at the end of the sequence.
Important:
Time must be entered using a 24-hour format (8AM=0800, 3PM=1500 etc. )
2 Short Beeps:
If you make an error during an entry, press the asterisk key (
9, 5, 3, 7, 2, 1,
Directory Codes
Entry Codes
Access Cards
Transmitter Codes
Time Zones
Access Codes from Database
Optional Steps Indicated with a
To enter programming mode from the EL25:
and the 6-Digit Password (2 short beeps will be heard)
Programming input is valid.
Page 5
Factory
Programming Procedure
Setting
104 # (alarm option; 0 = disable, 1 = enable until
relay time expires, 2 = enable until alarm clears) #
Disabled
(relay group, 0000-1111) #
Order of relays is 4321
Enabled
105 # (0 = disable; 1 = enable) #
No
109 # (0 = no; 1 = yes) # Default is "No"
110 # (directory code) # (phone extension delay) #
No Delay
(call forward extension delay) #
111 #
Disabled
113 # (0 = disable; 1 = enable) # (0-9, when enabled) #
115 # (normal-00, mixed-01, asterisk-02, pound-03,
Normal
number-1n) # each unit in chain must have same setting
116 # (activate door 1) # (activate door 2) # (activate
door 3) # (activate door 4) # (call wait toggle) #
*
(extend talk time) # (hang up and deny access) #
120 #
121 # (door 1-4) #
122 # (door 1-4) # (end time = hhmm) #
123 # (door 1-4) # (end time = hhmm) #
124 # (door 1-4) #
131 # (relay 1-4) #
201 # 101010 #
202 # 101010 #
203 # 101010 #
204 # 101010 #
205 # 101010 #
206 # 101010 #
Background, all other steps are Required
1 Long Beep:
Input is not valid.
) to begin again.
*