Chamberlain Elite EL25 Quick Start Manual page 2

Guide for Programming the EL25
Programming
Description of Task
Number
*** Entering Programming Mode
0
Exiting Programming Mode
1
Change or Verify the Unit's Password
2
Set Unit ID Number and No. in Chain
3
Set the Clock
4
Enable/Disable Daylight Savings Time
5
Set Visitor Talk Time
6
Set Directory Code Length
7
Set Entry Code Length
9
Enable/Disable Call Waiting
10
Enable/Disable Do Not Disturb Schedule
11
Enable/Disable Unlock Time Zone
12
Enable/Disable Anti-Passback
13
Set Anti-Passback Time
Set Maximum Number of Rings
14
Allowed Before Aborting Attempt
Set Standard Single Ring or Double
15
Ring Response
16
Number of Rings Before Unit Answers
17
Set "Strikes" and "Out"
18
Set Speaker Volume
19
Set Microphone Volume
20
Enable/Disable the Telco Mode
21
Enable/Disable Direct Commands
22
Enable/Disable Voice Mail
23
Enable/Disable Access Granted Beeps
24
Enable/Disable Real-Time Monitoring
The Pound Key (#) must be used as Data Field Separator and to Save Data at the end of the sequence.
Important:
Time must be entered using a 24-hour format (8AM=0800, 3PM=1500 etc. )
2 Short Beeps:
If you make an error during an entry, press the asterisk key (
Unit ID 1, Chain No. 1
Optional Steps Indicated with a
Programming input is valid.
Page 1
Factory
Programming Procedure
Setting
(6 Digit Password)
***
0 #
000000
1 # (1 to change; 2 to verify) # (six-digit code) #
2 # (unit ID number, 1-7) # (Number of Units in Chain, 1-7) #
3 # yymmdd # (day of the week) # hhmm #
Enabled
4 # (0 = disable; 1 = enable) #
60 Seconds
5 # (15 – 250 seconds) #
2 Digits 6 # (1 or 2) #
4 Digits
7 # (3-9) #
Enabled
9 # (0 = disable; 1 = enable) #
Disabled 10 # (directory code) # (0 = disable; 1 = enable) #
Enabled
11 # (0 = disable; 1 = enable) #
12 # Enable/Disable True Anti-Passback (0 = disable;
Disabled
1 = enable) # Enable/Disable Timed Anti-Passback (0
= disable; 1 = enable) #
3 Minutes
13 # (1-60 minutes) #
5 Rings
14 # (1 – 9) #
0 = One
15 # (0 – 1; 0 = one long ring, 1 = double ring) #
Long Ring
5 Rings
16 # (0 – 15) # Each unit in chain must have same setting
3 Errors
17 # (max errors, 0-5) #
5
18 # (0 = mute; 1-10, 1 is low and 10 is high) #
5
19 # (0 = mute; 1-10, 1 is low and 10 is high) #
Enabled
20 # (0 = disable; 1 = enable) #
Enabled
21 # (0 = disable; 1 enable) #
Disabled 22 # (0 = disable; 1 = enable) #
Enabled
23 # (0 = disable; 1 = enable) #
Disabled
24 # (0 = disable; 1 = enable) #
Background, all other steps are Required
1 Long Beep: Input is not valid.
) to begin again.
*