Table of Contents
Advertisement
SC-F9300 Series
User's Guide
:
The amount of ink is estimated to be
low.
Prepare a new ink pack.
:
The estimated amount of ink is near
its limits. Check the amount of ink,
and replace the chip unit and refill the
ink with one pack of ink if the
remaining ink is 70 mm or less from
the bottom of the ink tank. If the
remaining ink is more than 70 mm
from the bottom of the ink tank,
continue to use the printer until it is
below 70 mm before replacing and
refilling.
:
Printing has stopped because the
estimate amount of ink has reached
its limits.
Replace the chip unit and refill the
ink with one pack of ink.
The bottom of the indicators changes according
to the status of the chip unit, as shown below.
:
A chip unit for automatic charging
mounted.
When the estimated amount of ink
starts to run out, a low ink warning
does not occur. Refill the ink with one
pack of ink if the remaining ink is 70
mm or less from the bottom of the ink
tank.
:
(When flashing)
The chip for automatic charging
that was mounted has been removed.
Lowering the lock levers displays the
normal icon.
The chip unit you removed is as good
as new.
:
Automatic charging cannot be done
because the lock levers are raised.
Lower the lock levers.
Introduction
/
:
* When a chip unit is mounted on the printer, the information
about the available amount of ink in the ink pack that is
registered to the new chip unit is automatically written to the
printer. Writing the chip unit information to the printer is
called "charging".
When charging is complete, the indicator levels become full,
and the icon for the charge status turns gray. After charging,
the chip unit that was mounted on the printer is no longer
needed.
Charging occurs automatically when the indicator level
reaches 0 if you remove a chip unit that is no longer needed
and replace it with a new chip unit.
Mounting a new chip unit on the printer to do automatic
charging is called "reserving".
*
is
Reserving can be done at any time if the indicator's level for
the estimated amount of ink is between 1 and 6.
2 Ink color codes
HDK : High Density Black
Y
: Yellow
M
: Magenta
*
C
: Cyan
F
Waste Ink Bottle status
Displays the approximate amount of space available
in the Waste Ink Bottle. The display changes as
shown below when the waste ink bottle is nearly full
or an error occurs.
Normal
15
This refers to one of the following
statuses.
Reposition the chip unit, or replace it
with a correct chip unit.
❏
The chip unit has been mounted
incorrectly.
❏
A chip unit for an ink pack of a
different color than the ink tank is
mounted.
❏
A chip unit for an ink pack that is
incompatible with this printer is
mounted.
Warning or error
Advertisement
Table of Contents
