Table of Contents
Advertisement
SC-F9300 Series
User's Guide
Supported Media
The following media can be used with the printer.
Print quality is greatly affected by the type and quality of
media used. Choose a media suited to the task at hand.
For information on use, refer to the documentation
supplied with the media or contact the manufacturer.
Before buying media in large quantities, try printing on
a smaller sample and check the results.
Caution:
Because the media is heavy, it should not be carried
by one person.
We recommend using a lifter for media that weighs
over 40 kg.
c
Important:
Do not use media that is wrinkled, scuffed, torn, or
dirty.
Roll media
Roll core size
2 or 3 inch
Roll outer diameter
Up to 250 mm
Media width
300 to 1626 mm (64 inch)
Media thickness
0.04 mm to 1.00 mm
Roll weight
Maximum 45 kg
* The specifications for lifters that can be used to load media
that weighs over 40 kg are as follows.
• Thickness of the fork and table: under 28 mm
• The surface of the fork and table can be lowered
approximately 190 mm from the floor.
Appendix
Moving and Transporting
the Printer
This section describes how to move and transport the
product.
Moving the Printer
This section assumes that the product is being moved to
another location on the same floor without traversing
stairs, ramps, or lifts. See below for information on
moving the printer between floors or to another
building.
U
Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to observe
this precaution could result in the printer falling
over, causing accidents.
Getting Ready
A
B
*
C
D
118
"Transport" on page 119
Caution:
Confirm that the printer is off.
Remove the Waste Ink Bottle.
"Replacing the Waste Ink Bottle" on
U
page 74
Disconnect the power cords and all other cables.
Remove media from the Media Feeding Unit and
Auto Take-up Reel Unit.
Advertisement
Table of Contents
