Status And Notice Messages - Kohler 24RCLA Operation

2.6.5

Status and Notice Messages

The Status and Notice messages shown in Figure 2-6
are displayed during generator set operation. These
informational messages do not indicate faults.
Message
Advance Diagnostic Active
Advance Diagnostic Active Ended
Always On
Ats Exercise Active
ATS Exercise mode End Prematurely
Ats Loaded Test Active
Ats Position Source 1 selected
Ats Position Source 2 selected
ATS Test End
Ats Test Ended Prematurely
Ats Unloaded Test Active
Auto Recovery
Backup Parameter Loaded
Default Parameters Loaded
Diagnostic Exercise Active
Emergency Power System Supplying
Load
Engine Cool Down Active
Engine Start Delay Active
Engine Started
Engine Stopped
Exercise mode End
File System Error
Forced to Auto Status
Generator Running
Load Priority X Shed
Loaded Full Speed Exercise Active
Maintenance Timer Reset
Normal Power Source Unavailable
Remote Start
Unloaded Full Speed Exercise Active
Figure 2-6 Status and Notice Messages
28 Section 2 Generator Set Operation
Type Description
Status During any exercise mode, shutdown occurs due to any other
condition(Fault) excluding Emergency Shutdown, Main Power
Overloaded Shutdown, Low Cranking Voltage Shutdown.
Status Advance Diagnostic mode is ended
Notice Any of the following optional boards are connected to controller
1. LCM
2. PIM
Notice The generator is in exercise mode.
Status Exercise mode ends prematurely.
Status The ATS contactor position is source2 and user places the
controller in RUN mode.
Status The ATS contactor position is source1.
Status The ATS contactor position is source2.
Status ATS Test ended.
Status ATS Test ended prematurely.
Status Generator is started by pressing RUN Button.
Status Unit has reset due to unexpected error.
Status Test event log command is initiated from Site Tech.
Status When the engine stops, status is updated.
Status Variable speed exercise is running.
Notice The utility power is absent and the generator is powered on.
This notice is displayed on SiteTech.
Notice The generator is in cool down mode.
Notice The engine start delay is active.
Status When the engine starts, status is updated.
Status When the engine stops, status is updated.
Status Exercise mode ended.
Status Parameter/event saving fails after 3 retries.
Status Mode has changed to AUTO mode.
Notice The engine is started and a valid engine speed has been
achieved. This notice is displayed in SiteTech.
Notice Priority X (1- 6) load with is disconnected.
Status Loaded full speed exercise is running.
Status The user has reset the maintenance timer.
Notice Utility power is unavailable.
Status The remote start switch is pressed.
Status Unloaded full speed exercise is running.
TP-6905 9/21