Supermicro X11DSF-E User Manual page 12

Super X11DSF-E User's Manual
Quick Reference Table
Jumper Description
JBT1 CMOS Clear
JPB1 BMC Enable/Disable
JPQAT1 QAT Enable/Disable
JPQAT2 QAT Enable/Disable
JPL1 GLAN Enable/Disable
JPME2 Manufacturing Mode
JWD1 Watch Dog Timer Enable
Connector Description
BT1 Onboard CMOS battery
CPU1 CN1-CN3, PCIe x32 Tray Cable connector interface (GPU, NVMe, M.3, or Ruler down device w/VMD support)
CPU2 CN4-CN6 (See note below.)
FAN1 ~ FAN8 System/CPU fan headers (FAN1: CPU Fan)
JCOM1 COM port
JF1 Front Control Panel header
JGPW1 - JGPW4 Power connectors used for GPU and VGA devices
JIPMB1 System Management Bus header for IPMI 2.0
JIPMILAN IPMI-Dedicated LAN port
Chassis intrusion header (Note: Please connect a cable from the Chassis Intrusion header at JL1
JL1
to the chassis to receive an alert via IPMI.)
JLAN1/JLAN2 10G LAN ports 1 and 2
JRK1 Intel VROC RAID key header for NVMe Solid State Devices (SSD)
JS1 (I-SATA0 ~I-SATA7) SATA 3.0 ports supported by Intel PCH
JSD1 - JSD2 SATA Disk-on-module (DOM) power connectors
JSEN1 SMCI-Proprietary Inlet Temperature Sensor Cable connector (JSEN1:RT0)
JTPM1 TPM/PORT80 Port 80 connector for Trusted Platform Module (TPM)
JUIDB2 Unit Identifier (UID) switch
JUSB3 USB4/5 (3.0) Internal USB header for two USB 3.0 connections (USB4/5)
JUSB1 USB2/3 (3.0) USB 3.0 rear port (USB2/3)
JUSBA1 Type A USB 3.0 header
JVGA1 VGA port
PSU1 Power Supply Unit 1
Note: To avoid interference with other components, please be sure to use an add-on
card that is fully compliant with the PCI Standards on a PCI slot.
Default Setting
Open (Normal)
Pins 1-2 (Enabled)
Pins 2-3 (Disabled)
when JPQAT1 is Enabled:
Pins 1-2 x16 Uplink
Pins 2-3 x8 Uplink (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Reset)
12