Toshiba RS-TX20 Viewer's Manual page 23

Make sure the satellite cable from the wall is connected to your satellite box.
Connect a Composite A/V cable from the Audio/Video Output jacks on the satellite
box to the Audio/Video Input 1 jacks on the back of the DMS.
Connect the Coaxial RF cable from your antenna or cable source to the
Cable/Antenna-RF In jack on the DMS.
Connect a Composite A/V cable from the Audio/Video Output jacks on the DMS to
the Audio/Video Input jacks on your TV.
Connect the phone cord (see page 8). After you complete Guided Setup, you can
connect your DMS to a home network and use a broadband Internet connection instead
of a phone line to connect to the TiVo service. See Chapter 8.
Connect a channel changing cable (see the diagrams to the right).
Plug in all power cords and turn on your TV.
Set your TV to display video from the input jacks you used in step
to find the correct TV input setting by pressing the Input or TV/Video button on your
TV's remote control until you see the Welcome screen. (For more help, see page 131.)
Once you see the Welcome screen, you're ready to complete Guided Setup. If you need
help, see Chapter 2.
S e t u p 3 : S a t e l l i t e B o x & R F P r o g r a m S o u r c e
Connect a Channel Changing Cable
(See page 5 for help choosing a channel
changing cable.)
Serial Control cable:
one end of the Serial Control
cable into the Serial/Data
connector on the cable or
satellite box. Plug the other
end into the Control Out-Serial connector (the upper
mini jack) on the back of the DMS.
IR Control cable:
(a) Plug the purple end of the IR Control cable into
the Control Out-IR connector (the lower mini-jack)
on the DMS.
. You may have
help). (c) Mount the IR emitters. Place one emitter
on top of the cable/satellite box and the other
underneath it. Be sure both emitters stick out about
1.5 inches directly in front of the IR sensor. Use the
provided adhesive strips to hold the emitters in place.
Cable or
Satellite Box
b
Digital Media
Server
®
Plug
Serial Control
cable connection
Serial
(b) Locate the IR sensor (see page 6 for
c
a
IR Control cable connection
1
15