Toshiba RS-TX20 Viewer's Manual page 127

C o n n e c t i n g t o a H o m e N e t w o r k U s i n g W i r e d ( E t h e r n e t )
Connecting to a Home Network Using Wired
(Ethernet)
This example shows you how to connect a DMS to a network hub using a wired (Ethernet)
network adapter. You can leave your DMS plugged in while you connect a network
adapter.
To connect a wired (Ethernet) network adapter to your DMS and your network hub,
follow these steps:
1. Connect to the DMS. Connect the USB end of the Ethernet adapter to the USB port on
the DMS.
2. Connect Ethernet to the adapter. Plug one end of an Ethernet cable into the Ethernet
adapter.
3. Connect Ethernet to the hub or router. Plug the other end of the Ethernet cable into
your home network's hub or router.
Do not use the CDs that are included
with your network adapters to set
®
up your DMS. These CDs are intended to
load drivers and network adapter software
on your personal computer.
8
119