Table of Contents
Advertisement
EASY MENU DRIVEN PROGRAM MODE
DEALER PROGRAM - PRELIMINARY INFORMATION
The Default Dealer Code is
gram a custom Dealer Code, which replaces the Default Dealer Code. If you clear your Dealer Code, use the Default Dealer
Code once again to enter programming.
After entering codes or data, press the save
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound.
Silence the sounder by the
A panel that has been COLD STARTED (Address Location 2286) performs identically to a new panel.
When programming a Multiple Area System, Direct Address Programming Mode must be used to complete the program.
For ease of programming, it is recommended that a GEM-DXRP1 or GEM-DXK1 be used. For Programming Instruc-
tions with the GEM-DXRP2 / GEM-DXK2, GEM-DXRP3 / GEM-DXK3 and the GEM-DXK4RF series, see WI1771.
ACCESSING DEALER PROGRAM MODE
1. Press
456789 w
2. Press PRIOR ("
3. Press NEXT ("r" or
4. Press
yy
CUSTOMIZING A DEFAULT PROGRAM
For new panels, you can design a default program that will best suit your application. Using this procedure, you will configure the panel for:
•
Number of Zones in Area 1
•
Panel Zone Doubling
•
Fire Zones in Area 1
•
2-Wire Fire Zones in Area 1
•
Local or Central Station Reporting System
•
Exit/Entry Zones in Area 1
•
Interior Zones in Area 1
•
24 Hour Zones in Area 1
•
Chime Zones in Area 1
•
Chime 2 Zones in Area 1
•
Exit/Entry2 Zones in Area 1
This procedure will automatically set up system keypads, wireless transmitters, etc. After your basic default program has been
loaded, you may alter it as necessary in the Direct Address Program Mode.
NEW PANELS: The custom default program may be created for new panels only. Once the panel has been programmed by any
means, the number zones will be suppressed and cannot be changed. Should it be necessary to create a new custom default pro-
gram, (a) from the Dealer Program Mode, press the
2285 (Clear Program); (c) press the
NAPCO Security Systems
456789
u
button. Data will not be stored into memory unless
button to continue, or by pressing the
G
Dealer Code
" or
) button until "ACTIVATE PROGRAM Y/N" appears on LCD screen.
X
q
) button to Enter Dealer Program Mode.
p
to Exit Dealer Program Mode when finished.
•
50mS Loop Response Zones
•
Aux Output Activated on Alarm Zones
•
Sensor Watch Zones
•
Keypad Sounder on Alarm Zones
•
Auto Bypass re-entry Zones
•
Enable no EOLR Zones
•
Enable Telco Line Fault Test
•
Enable Burg Output Chirp on Keyfob
•
Enable CP-01 Programming
•
Number of Keypads in Area 1
•
Central Station Receiver 1 Tel. Number
y
u
button and start over.
. Use this code to enter the Dealer Program Mode to pro-
y
button to exit.
button to enter the Direct Address Program Mode; (b) access Location
LIBRA LIB-P432EX Series Programming Instructions
u
is pressed.
•
Central Station Receiver 1 Account Number
•
Central Station Receiver 1 Format
•
Enter User Codes
•
RF Transmitter Points
•
Quick "Enroll" Method
•
Key Fob Transmitters
•
Enter Zone Descriptions
•
Enter Date
•
Enter Time
•
Dealer Code
•
Test Timer
Page 5
Advertisement
Table of Contents
