The Front Panel Leds - ZyXEL Communications ZyXEL Prestige 662HW Compact Manual

LABEL
CON/AUX Only connect this port if you want to configure the Prestige using the
switch SMT via console port see your User's Guide for details.
CON/AUX
Set this switch to the CON side to use the CON/AUX port as a console
port
port for local device configuration and management. Connect the RJ-45
end of the console cable to the console port of the Prestige and the
other end to a serial port (COM1, COM2 or other COM port) on your
computer. Your computer should have a terminal emulation
communications program (such as HyperTerminal) set to VT100
terminal emulation, no parity, 8 data bits, 1 stop bit, no flow control and
9600 bps port speed.
The console port is also an auxiliary WAN port. Push the CON/AUX
switch to AUX and connect the CON/AUX port to your modem or TA.
RESET You only need to use this button if you've forgotten the Prestige's
password. It returns the Prestige to the factory defaults (password is
1234, LAN IP address 192.168.1.1 etc.; see your User's Guide for
details).

2.2 The Front Panel LEDs

Refer to the following table for more detailed LED descriptions.
LED COLOR
PWR/SYS Green
Prestige 662HW Series Compact Guide
Table 1 Rear Panel Description
Figure 2 Front Panel
Table 2 Front Panel LED Description
STATUS
On The Prestige is receiving power and functioning
properly.
DESCRIPTION
DESCRIPTION
5