Client Mode Status Screen - ZyXEL Communications WAP3205 User Manual

Note: The client mode IP address is always the same as the access point mode IP
address. If you changed the IP address of your WAP3205 while in access point
mode, use this IP address in client mode.

7.5 Client Mode Status Screen

Click
Figure 33 Status: Client Mode
The following table describes the labels shown in the Status screen.
Table 15 Status Screen: Client Mode
LABEL
Logout
Device Information
Host Name
Firmware Version
Sys OP Mode
LAN Information
MAC Address
IP Address
IP Subnet Mask
WAP3205 User's Guide
to open the status screen.
DESCRIPTION
Click this at any time to exit the Web Configurator.
This is the System Name you enter in the Maintenance > General
screen. It is for identification purposes.
This is the firmware version and the date created.
This is the device mode
is set - Client Mode.
This shows the LAN Ethernet adapter MAC Address of your device.
This shows the LAN port's IP address.
This shows the LAN port's subnet mask.
(Section 3.1.2 on page 29) to which the WAP3205
Chapter 7 Client Mode
71