ZyXEL Communications WAP3205 User Manual page 77

Table 19 Client Mode: WLAN > Profile: WEP
LABEL
Authenticatio
n Method
ASCII
Hex
Key 1 to Key
4
Apply
Cancel
7.6.1.3 WPA(2)-PSK
Use this screen if the access point to which you want to connect uses WPA(2)-PSK
security mode.
Figure 38 Client Mode: WLAN > Profile: WPA-PSK/WPA2-PSK
WAP3205 User's Guide
DESCRIPTION
Select Open or Shared Key from the drop-down list box.
This field specifies whether the wireless clients have to provide the WEP
key to log into the wireless network. Keep this setting at Open unless you
want to force a key verification before communication between the
wireless client and the ZyXEL Device occurs.
Select Shared Key to force the clients to provide the WEP key prior to
communication.
Select this option in order to enter ASCII characters as WEP key.
Select this option in order to enter hexadecimal characters as a WEP key.
The preceding "0x", that identifies a hexadecimal key, is entered
automatically.
The WEP keys are used to encrypt data. Both the WAP3205 and the
wireless stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10
hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26
hexadecimal characters ("0-9", "A-F").
You must configure at least one key, only one key can be activated at any
one time. The default key is key 1.
Click Apply to save your changes back to the WAP3205.
Click Cancel to go back to the previous screen.
Chapter 7 Client Mode
77