Starting Otist; Figure 43 Zyxel Device In Wireless Client Mode: Otist Screen; Figure 44 Security Key - ZyXEL Communications G-570S User Manual

7.9.1.3.1 Wireless Client Mode: OTIST Button
If you use the OTIST button, the default (01234567) or previous saved (through the web
configurator) Setup key is used.
Double-click the OTIST button to automatically change the ZyXEL Device to wireless client
mode and start OTIST.
7.9.1.3.2 Wireless Client Mode: Web Configurator
Start the web configurator and click Wireless. Select Wireless Client in the Operation Mode
field.
Click on the OTIST tab. The screen displays as shown. Enter the same Setup Key as your
AP's. Click Start when you are ready to begin OTIST.

Figure 43 ZyXEL Device in Wireless Client Mode: OTIST Screen

7.9.2 Starting OTIST

You must click Start in the AP OTIST web configurator screen and in the
wireless client(s) Adapter screen all within three minutes (at the time of
writing). You can start OTIST in the wireless clients and AP in any order but
they must all be within range and have OTIST enabled.
1 In the AP, a web configurator screen pops up showing you the security settings to
transfer. After reviewing the settings, click OK.

Figure 44 Security Key

2 This screen appears while OTIST settings are being transferred. It closes when the
transfer is complete.
ZyXEL G-570S User's Guide
Chapter 7 Wireless Screens
83