The Web Configurator; Introducing The Web Configurator; Accessing The Web Configurator; Figure 3-1 Entering Vsg Ip Address In Internet Explorer - ZyXEL Communications ZyXEL Vantage VSG-1000 User Manual

This chapter introduces how to access the web configurator and perform general system configuration.

3.1 Introducing the Web Configurator

The web configurator is best viewed with Internet Explorer (version 5.0 or above) or Netscape (version 6.0 or
above) with JavaScript support enabled.

3.2 Accessing the Web Configurator

All web configurator screens are shown in Internet Explorer. Follow the steps below to access the web configurator.
The VSG allows only one login session at any one time using the web configurator.
Make sure your VSG is properly connected (refer to instructions in the chapter on hardware installtion).
Step 1.
Launch your web browser and type the WAN IP address (192.168.1.1 is the default) of the VSG as the
Step 2.
web address.
If you are using a different port number (between 8000 and 8099) for the web server, you must also
append the port number to the WAN IP address seperated with a colon ":",for example,
http://192.168.1.1:8080.
A login screen displays. The firmware version number is displayed in the login screen. Type "admin"
Step 3.
(default) as the user name and "1234" (default) as the password and click Enter.
You should see the main screen as shown.
Step 4.

The Web Configurator

You must access the web configurator through the WAN.

Figure 3-1 Entering VSG IP Address in Internet Explorer

The user name and password are case sensitive.

Figure 3-2 Web Configurator: Login

VSG-1000 Vantage Service Gateway
The Web Configurator
Chapter 3
3-1