Nautilus T628 Assembly Manual / Owner's Manual page 37

10. The Console display shows the WIRELESS HR prompt. If you are using the Console speakers at their higher settings
and / or using a larger sized personal electronic device, the Console may show Heart Rate interference. This option
allows the Telemetry Heart Rate Receiver to be deactivated blocking the interference.
The Display shows the current value setting: "ON" or "OFF". Push the Increase( ) or Decrease( ) buttons to change
the value. The default is "ON".
Push the OK button to set the Telemetry Heart Rate Receiver to active.
11. The Console will go to the Power-Up Mode screen with the user selected.
Reset a User Profile
1. From the Power-Up Mode screen, push the User button to select one of the User Pro les.
2. Push the OK button to select the User Profile.
3. The Console display shows the GOAL TRACK prompt. Push the Decrease ( ) button to change the prompt.
Note: To e it the User Pro le options, push the PAUSE/STOP button and the console will go back to the Power-Up
Mode screen.
4. The Console display shows the RESET prompt and the current User Profile name. Push OK to start the Reset User
Pro le option.
5. The Console will now confirm the request to reset the User profile (the default selection is 'RESET - NO'). Push the
Increase( ) or Decrease( ) buttons to adjust the selection.
6. Push OK to make your selection.
7. The Console will go to the Power-Up Mode screen.
Changing Incline Levels
Push the Incline Level Increase( ) or Decrease( ) buttons to change the incline angle
of the Deck at any time with the Safety Key installed. To rapidly change the incline level
push the desired Pre-Set Incline Button, and then the Incline Enter Button. The Deck will
adjust to the selected incline level.
Note: After a Pre-Set Incline Button is pushed, the Incline Enter Button must be
pushed within 12 seconds.
lower the Deck after each workout.
anticipate that changes in belt speed and incline angle of deck can occur
during workouts, and be attentive in order to avoid loss of balance and
possible injury.
Be sure that the workout space you are utilizing has adequate height clearance, taking
into consideration the height of the user and the ma imum height of the fully inclined
Deck.
Changing Speed Levels
Push the Speed Level Increase( ) or Decrease( ) buttons to change the Belt Speed at any time in a workout program.
To rapidly change the Speed level push the desired Pre-Set Speed Button, and then the Speed Enter Button. The Walking
Belt will adjust to the desired speed.
Note: After a Pre-Set Speed Button is pushed, the Speed Enter Button must be pushed within 12 seconds.
Pre-Set Incline
Buttons
Incline
Enter
Button
37