Omron V680S-HMD64-EIP User Manual page 62

Section 3
Names and Functions of Components
 Operation Indicators

RUN
Status
Lit green Lighting while the Reader/Writer is operating normally.
Flashing Flashes during operation in Safe Mode. (Flashes at 1-s intervals.)
green
Flashing The indicator will flash quickly in the following cases. (Flashes at 200-ms intervals.)
green
• During Reader/Writer initialization
quickly
• While the Reader/Writer is in Run Mode and is waiting to establish tag data links as the originator
Lit yellow Lights yellow while the Reader/Writer is operating in Slave Mode.
Flashing Flashes quickly while the Reader/Writer is in Slave Mode and is waiting to establish tag data links as the originator.
yellow
quickly
Not lit Turn off when power is not supplied.
 RF
Status
Lit yellow Lighting during communication for RF Tag.
Not lit Turn off when not in communication with no error.
 NORM/ERR
The NORM/ERR indicator shows the result of communications with an RF Tag.
Status
Lit green Lights once when processing a communications command or another command from the host device is completed normally.
When communication diagnostic is enabled, this indicator will flash once each time a stable communication is detected.
Lit yellow When communication diagnostic is enabled, this indicator will flash once each time an unstable communication is detected.
Flashing Flashes quickly when a timeout is detected during tag data links. (A timeout occurs when tag data from the originator is not
yellow received within the time specified for the timeout value.)
quickly
Lit red Lights once when processing a communications command or another command from the host device ends in an error. It
continues to light if a system error occurred.
Flashing Flash when recoverable error occurs. (Configuration memory error, or Control signal wiring mistake, etc.)
red
Flashing The indicator will flash irregularly in the following cases. (It will repeatedly flash twice for 100 ms at 1-s intervals.)
red
• When the same IP address is detected for two different devices on the network at startup
irregularly
• When an error occurs when getting an IP address from the BOOTP server at startup (The BOOTP server does not respond.
The IP address from the BOOTP server to set in the Reader/Writer is illegal.)
Not lit Turn off when the standby state.
 LINK/ACT
Status
Lit green Lighting during linking normally.
Flashing Flash during detects a carrier.
green
Not lit Turn off when the ethernet cable is not connected.
Refer to Errors and Indicator Status in Section 9 Troubleshooting for information of Error content of the operation indicator
p.216
RFID System
60
User's Manual
(EtherNet/IP TM )
Meaning
Meaning
Meaning
Meaning