Omron V680S-HMD64-EIP User Manual page 155

 Error Codes
The following tables list the error codes that indicate the response results from the Reader/Writer.
These codes are set in the Error Code field in the response area.
If an error response is returned (i.e., an error code other than 0000 hex), a record is stored in the
command error log in the Reader/Writer. Records are not stored for errors for which responses are not
returned to the host device. Reader/Writer operating errors and system errors are recorded in the
system error log in the Reader/Writer.
 Normal Code
Error code name
Normal end
 Interrupted Processing
Error code name
Communications canceled
Communications aborted
 Command Errors
Error code name
Unknown command error
Command parameter error
Execution status error
 RF Tag Communications Errors
Error code name
RF Tag missing error
RF Tag communications error
UID mismatch error
RF Tag address error
RF Tag lock error
Verification error
RF Tag data lost error
RF Tag system error
RF Tag overwriting error
Reader/Writer connection error
Communications connection
error between Reader/Writers
Error code
0000 hex Processing ended normally.
Error code
Processing was canceled when an OFF EXE signal was received before
0001 hex an RF Tag was detected. (The contents of the RF Tag was not changed,
even for a WRITE DATA command.)
Processing was canceled when an OFF EXE signal was received during
0002 hex communications with an RF Tag. (For a WRITE DATA command, the
contents of the RF Tag may have been changed.)
Error code
1003 hex A command that is not supported by the Reader/Writer was received.
1005 hex There was an error in the parameters in the received command data.
1006 hex The Reader/Writer could not execute the command that was received.
Error code
2001 hex There is no RF Tag in the communications field.
2002 hex Communications with the RF Tag did not end normally.
2003 hex An RF Tag with the specified ID was not in the communications field.
The access address for the RF Tag is outside of the area supported by
2004 hex
the target RF Tag.
2005 hex An attempt was made to write data to a locked area.
2006 hex Processing to write data to the RF Tag did not end normally.
Processing to write data to the RF Tag did not end normally. (Data may
2007 hex
have been lost and must be restored.)
2008 hex The RF Tag returned an error response.
2009 hex The overwrite limit was exceeded for overwrite count control processing.
When executing the COPY DATA command, communications could not
200A hex
be established with the copy destination Reader/Writer.
When executing multi-Reader/Writer functions, communications could
200B hex
not be established with a Slave Reader/Writer.
Host Communications Specifications
Description
Description
Description
Description
Section 7
RFID System
153
User's Manual
(EtherNet/IP TM )