Remote Start Time-Out Alert; Manual Transmission Start (Mts Mode) - Viper 5902 Owner's Manual

perature changes. If a change in temperature is detected this report
will be sent to the remote for display. Each time the remote receives
this report it will beep, update, and display the newest temperature
information in the Status screen info center.
Note
Temperature report must be turned on by an authorized Di-
rected dealer.

Remote Start Time-out Alert

During remote start a message is sent three minutes before
and again at one minute before the engine turns off. The
REMOTE START TIMEOUT IMMINENT
to reset the runtime if desired.

Manual Transmission Start (MTS mode)

When installed into a manual transmission vehicle, the system requires
that the MTS mode is properly set when parking. If MTS mode is not
properly set or is defeated after being properly set the system will
not start the engine and the
tones play as an alert.
1. With the engine running,
engine running. For Pit Stop or Turbo Timer mode (to leave the
engine running after arming) open the driver door.
Release
2.
release the foot brake anytime. As long as the engine is running
there is no time limit to perform this step.
3. Within 20 seconds of foot brake release,
button on the remote, after 20 seconds return to Step 2 (For Turbo
Timer Mode, press the optional dash mounted activation button
or send the Timer Mode command from the Advanced Start menu
42
the foot brake (if pressed during Step 1), or press and
animation and tones play as an alert
REMOTE START NOT AVAILABLE
set the parking brake and leave the
© 2009 Directed Electronics. All rights reserved.
screen and
press any command