Sensor Adjust; Placing System Into Remote Pair Mode - Viper 5902 Owner's Manual

Placing the system into the remote pair mode
Open
1. one or more of the vehicle doors.
Turn
2. the ignition to the On position.
Press , release, then press and hold the Control button (on Con-
3.
trol Center).
4. The control center LED begins to flash and the siren emits one
chirp to confirm the system is in Pair mode, the Control button
can be released. The system will stay in Pair mode for 60
seconds or until the doors are closed or ignition turned off.
The siren will emit one short and one long chirp when it exits
remote pair mode.
Toggle
1. to
Pair screen with on-screen instructions is displayed.
Press and hold the
2.
the siren chirps, and remote tones play to confirm pairing. The
PAIRING SUCCESSFUL
Adjustments feature menu screen.
3. If the remote does not learn the system ID it displays the
PAIRING FAILED
turning to the Remote Pair screen. Press and hold the
button to try again. If the siren chirps but remote tones are not
played, Press and hold the
tones are played. If the siren does not chirp shortly after the
remote LED begins flashing make sure the system is in remote
pair mode.

Sensor Adjust

Your Responder HD security with remote start system has a built in
shock sensor used to detect intrusion attempts on your vehicle. The
sensor sensitivity can be adjusted to optimize your vehicle's detection
© 2009 Directed Electronics. All rights reserved.
and press the menu wheel, the
Remote Pair
button. The remote's LED flashes, then
screen is displayed before returning to the
screen after the button is released before re-
button to try again until the
Remote
29