Glossary Of Terms - Viper 5101 Owner's Manual

Glossary of terms

Control Center: The control center contains the system's radio-frequency
antenna, the valet and override switch, and the Status LED. For maximum
remote-control range, the Control Center is usually located at the top of the
windshield, centered near the rear-view mirror.
Control Module: The "brain" of your system. Usually hidden underneath the
dash area of the vehicle. It houses the microprocessor which monitors your
vehicle and controls all of the system's functions.
Failsafe® Starter Kill (if equipped): An automatic switch controlled by the
system which prevents the vehicle's starter from cranking whenever the system
is locked. The vehicle is never prevented from cranking when the system is
unlocked in Valet® Mode, or should the starter kill switch fail. Your system
is ready for this feature, however installation of this feature may require ad-
ditional labor.
Input: Any physical connection to the system. An input can be provided by
existing systems in the vehicle, such as ignition or courtesy lights.
In-vehicle status LED: A light used to indicate the status of your system. It is
located on your systems control center.
MTS: Manual transmission start. Procedure required for using the remote start
in a vehicle with a manual transmission.
RF: Radio frequency
Valet Button: A small push button switch located on your systems control center.
It is used to override the starter interrupt when a remote is lost or damaged, or
to enter or exit Valet Mode.
33
© 2008 Directed Electronics. All rights reserved.