Timer Mode - Viper 5101 Owner's Manual

➤ Timer mode

This unit can be programmed to start and run the engine every three hours, for
a maximum of six cycles. The engine will run for the programmed run time and
then shut down. After three hours, the system will restart the engine.
Note: This feature works only when the system has been locked with the
remote.
Important:
Never start and run the vehicle in an enclosed space such
as a garage or carport.
To activate timer mode with an automatic transmission:
1. Press twice and then press
2. The parking lights quickly flash four times to confirm timer mode entry.
(The vehicle will not remote start at this point.)
3. The vehicle begins the timer mode sequence.
To activate timer mode with a manual transmission:
1. Enter the MTS mode.
2. Exit the vehicle and lock the system.
3. Enter the timer mode. The parking lights quickly flash 4 times to confirm
entry into timer mode (vehicle will not remote start at this point).
The vehicle begins the timer mode sequence.
Timer Mode is exited automatically after the sixth run cycle. The parking lights
slowly flash 4 times when exiting timer mode.
To exit timer mode with the transmitter:
• Press the
slow four times to confirm timer mode is exited.
© 2008 Directed Electronics. All rights reserved.
Timer Mode should be used in open areas only.
button twice and then press
.
A U X
. The parking lights flash
A U X
23