Turning On The Rear Defogger; Valet Take-Over - Viper 5101 Owner's Manual

➤ Turning on the rear defogger

The rear defogger (if connected) is programmed to automatically activate
when remote start is turned on. If the interior cabin temperature is above 55˚ F
the defogger will not activate.
To manually activate the rear defogger after remote start is on:
• Press four times, and then press
confirm the defogger activation.

➤ Valet take-over

The Valet take-over feature allows the vehicle to remain running after the key
has been removed from the ignition. This feature is useful for occasions when
you want to exit and lock the vehicle for short periods of time, but would like
to leave the motor running and the climate controls on.
To perform Valet take-over:
1. Before turning Off the engine, press and release the
transmitter.
The parking lights flash one time to confirm that valet -take-over has been
initiated Then wait a few seconds.
2. Turn the ignition key to the Off position (The engine remains running).
3. Exit the vehicle and lock the system with the remote.
The engine runs until the pre-programmed time elapses or a shut-down
input is received.
Note: To enable valet take-over with a manual transmission, open the door
when going into MTS mode. The parking lights flash five-times to confirm entry
into valet takeover. After you exit the vehicle you can lock the system with the
remote and the car remains running. If the vehicle shuts down when locking,
then the unit did not enter the valet take-over mode.
© 2008 Directed Electronics. All rights reserved.
. The parking lights flash 4 times to
button on the
A U X
27