Timer/Minute Minder - CDA Matrix MHN101FR User Manual

Timer/Minute Minder

The hob is equipped with a timer that allows a finish time to be set
for the end of cooking on any zone, between a minimum of 1 minute
and a maximum of 99 minutes. This timer can be used separately
for each zone, and an LED will indicate the zone positions for each
of the active timers. Once the timers are set, the timer display will
show the time remaining on the first zone to finish cooking. The timer
can also be used as a minute minder to count down time, when the
zones are not in use.
To set the timer
• First switch on the hob and set the desired zone to the power level
required.
• Whilst the relevant cooking zone indicator (7) is pulsating touch
the timer sensor (10). Using the higher heat setting selector (6) or
the lower heat setting selector (8), set the desired cooking time
(in minutes) to between 0 and 99. The selection will confirm in
approximately 2 seconds, the timer display will show the time set
and the countdown will start.
• If no time is set within ten seconds, the timer indicator light (12) will
become inactive and the zone will continue cooking.
At the end of the timer, the selected zone will switch off and the
timer display, and relevant time indicator light, will flash. The hob will
beep for approximately two minutes. To switch off the beep and the
flashing displays, touch any key. This beeping also occurs after the
minute minder time has elapsed and the same process to switch off
the beep applies.
12