Ricoh MFSP213SFNW1 Manual page 256

❖
Federal Communication Commission (FCC) Radiation Exposure Statement
This EUT is compliance with RF exposure for general population/uncontrolled
exposure limits in ANSI/IEEE C95.1-1999 and had been tested in accordance
with the measurement methods and procedures specified in OET Bulletin 65
Supplement C. This equipment should be installed and operated with mini-
mum distance 20cm between the radiator and your body.
Part 68 of the FCC Rules
❖
FCC Requirements
1) This equipment complies with Part 68 of the FCC rules and requirements adopted
by the ACTA. On the cover of this equipment is a label that contains, among other
information, a product identifi er in the format US:AAAEQ##TXXXXX. If requested,
this number must be provided to the telephone company.
2) This equipment uses the RJ11C USOC jack.
3) A plug and jack used to connect this equipment to the premises wiring and tele-
phone network must comply with the applicable FCC Part 68 rules and require-
ments adopted by the ACTA. A compliant telephone cord and modular plug is
provided with this product. It is designed to be connected to a compatible modular
jack that is also compliant. See installation instructions for detail.
4) The REN is used to determine the number of devices that may be connected to a
telephone line. Excessive RENs on a telephone line may result in the devices not
ringing in response to an incoming call. In most but not all areas, the sum of RENs
should not exceed fi ve (5.0). To be certain of the number of devices that may be
connected to a line, as determined by the total RENs, contact the local telephone
company. The REN for this product is part of the product identifi er that has the
format US:AAAEQ##TXXXXX. The digits represented by ## are the REN without a
decimal point (e.g., 03 is a REN of 0.3).
5) If this equipment causes harm to the telephone network, the telephone company
will notify you in advance that temporary discontinuance of service may be
required. But if advance notice is not practical, the telephone company will notify
the customer as soon as possible. Also, you will be advised of your right to fi le a
complaint with the FCC if you believe it is necessary.
6) The telephone company may make changes in its facilities, equipment, operations
or procedures that could affect the operation of the equipment. If this happens the
telephone company will provide advance notice in order for you to make necessary
modifi cations to maintain uninterrupted service.
7) If trouble is experienced with this equipment, for repair or warranty informa-
tion, please contact Ricoh Americas Corporation. CUSTOMER SUPPORT DEPT.
at 1-800- FASTFIX. If the equipment is causing harm to the telephone network,
the telephone company may request that you disconnect the equipment until the
problem is resolved.
8) In the event of operation problems (document jam, copy jam, communication error
indication), refer to the solving problems section in this manual.
9) Connection to party line service is subject to state tariffs. Contact the state public
utility commission, public service commission or corporation commission for infor-
mation.
10) If your home has specially wired alarm equipment connected to the telephone
line, ensure the installation of this equipment does not disable your alarm equip-
ment. If you have questions about what will disable alarm equipment, consult your
4
telephone company or a qualifi ed installer.