Ricoh MFSP213SFNW1 Manual page 147

I/O Timeout
• USB
Specifies how many seconds the machine waits for print data, if the data is interrupted while it
is being sent from the computer via USB. If the machine does not receive any more data within
the time specified here, the machine only prints the data it has received. If printing is frequently
interrupted by data from other ports, increase the timeout period.
Default: [60 sec.]
• 15 sec.
• 60 sec.
• 300 sec.
• Network
Specifies how many seconds the machine waits for print data, if the data is interrupted while it
is being sent from the computer via network. If the machine does not receive any more data
within the time specified here, the machine only prints the data it has received. If printing is
frequently interrupted by data from other ports, increase the timeout period.
Default: [60 sec.]
• 15 sec.
• 60 sec.
• 300 sec.
• Fixed USB Port
Specifies whether the same printer/PC-Fax driver can be used for multiple machines or not
under USB connection.
Default: [Off]
• Off
You must install the printer/PC-Fax driver separately for individual machines, because
the machine other than the original will be recognized as a new device upon USB
connection.
• On
The same printer/PC-Fax driver you have installed in your computer can be used with
any machine other than the one originally used for installation, if the machine is of the
same model.
Auto Continue
Sets the machine to ignore an error with paper size or type and continue printing. The printing stops
temporarily when an error is detected, and restarts automatically after about ten seconds using the
settings made on the control panel. However, if the size of paper specified on the control panel
and that of the paper loaded in the paper tray or the paper size specified for the print job do not
match when printing restarts, it may cause a paper jam.
opal-p2_mf2_com_user_guide_00142125_eng.xml
System Settings
147
Draft 2014/01/07