Table of Contents
Advertisement
The optional settings: [Disabled]; [Enabled].
SATA Mode Selection
The optional settings are: [IDE]; [AHCI]; [RAID].
*When set as [IDE] or [RAID], user can make further settings in 'IDE
Legacy/Native Mode Selection'.
IDE Legacy/Native Mode Selection
The optional settings are: [Native]; [Legacy].
*When set as [AHCI] or [RAID], user can make further settings in the following
items:
Aggressive LPM Support
Use this item to enable PCH to aggressively enter link power state.
The optional settings: [Enabled]; [Disabled].
SATA Controller Speed
The item is for user to set the maximum speed the SATA controller can support.
The optional settings are: [Default]; [Gen1]; [Gen2]; [Gen3].
*When set as [AHCI] or [RAID], user can also make further settings for each
available SATA (1~6) port or MSATA port:
Serial ATA Port 1/2/3/4/MMPE(mSATA)
Port 1/ Port 2/ Port 3/ Port 4/MMPE(mSATA)
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable each SATA port.
SATA Device Type
The optional settings are: [Hard Disk Drive]; [Solid State Drive].
Intel(R) Rapid Start Technology
Press [Enter] to go to next screen to enable or disable 'Intel(R) Rapid Start
Technology'.
*When set as [Enabled], user can also make further settings in the following items
that appear:
Entry on S3 RTC Wake
Use this item to enable or disable RapidStart innovation upon S3 RTC wake.
Entry After
Use this item to enable RTC wake timer at S3 entry. Value ranges from 0
28
Advertisement
Table of Contents
