ZyXEL Communications VMG1312-T10C User Manual page 48

Chapter 5 WAN Setup
Table 6 More Connections: Edit (continued)
LABEL
802.1p
DSCP
IP Address
Static IP Address
IP Address
Subnet Mask
Gateway IP
Address
Primary /
Secondary
DNS
IPv6 Address
Obtain an IP
Address
Automatically
Static IP Address Select this option if you have a fixed IPv6 address assigned by your ISP.
DHCP IPv6
DHCP PD
IPv6 Address
Prefix Length
IPv6 Default
Gateway
IPv6 DNS
Server1
IPv6 DNS
Server2
Connection
Keep Alive
Connect on
Demand
48
DESCRIPTION
This field is available only when VLAN is enabled.
Enter the IEEE 802.1p priority level for this WAN interface connection.
Enter a DSCP (DiffServ Code Point) value to have the Device add it in the packets sent by
this WAN interface.
You can use these options when you set the Mode field to Router and the IPv6/IPv4
Dual Stack field to IPv4 or IPv4/IPv6.
Select Obtain an IP Address Automatically if the ISP assigns you a dynamic IP
address; otherwise select Static IP Address and type your ISP assigned IP address in the
IP Address field below.
Select this option If the ISP assigned a fixed IP address.
Enter the static IP address provided by your ISP.
Enter a subnet mask in dotted decimal notation.
Specify a gateway IP address (supplied by your ISP).
Set how the Device gets the IP addresses of the DNS servers it uses.
UserDefined - enter a static IP address.
Obtained From ISP - when the Device gets its IP address automatically, you can select
this to have it also get the DNS server address.
None - the Device does not use the DNS server entry.
Select this option if you want to have the Device use the IPv6 prefix from the connected
router's Router Advertisement (RA) to generate an IPv6 address.
Select DHCP if you want to obtain an IPv6 address from a DHCPv6 server.
The IP address assigned by a DHCPv6 server has priority over the IP address automatically
generated by the Device using the IPv6 prefix from an RA.
Select SLAAC (Stateless address autoconfiguration) to have the Device use the prefix to
automatically generate a unique IP address that does not need to be maintained by a
DHCP server.
Select Enable to use DHCP PD (Prefix Delegation) to allow the Device to pass the IPv6
prefix information to its LAN hosts. The hosts can then use the prefix to generate their
IPv6 addresses.
With Static IP Address enabled, enter the IPv6 address of the Device in the WAN.
With Static IP Address enabled, enter the IPv6 prefix length in the WAN.
With Static IP Address enabled, enter the IPv6 address of the default gateway
With Static IP Address enabled, enter the primary DNS server IPv6 address for the
Device.
With Static IP Address enabled, enter the secondary DNS server IPv6 address for the
Device.
Select Keep Alive when you want your connection up all the time. The Device will try to
bring up the connection automatically if it disconnects.
Select Connect on Demand when you don't want the connection up all the time and
specify an idle time-out in the Max Idle Timeout field.
VMG1312-T10C User's Guide