Specifications - Panasonic SC-MAX7000 Operating Instructions Manual

"TEMP NG"
•
The temperature protection circuit has been activated, and
the system will switch off. Let the unit cool down before
switching it on again.
• Check that the ventilation opening of the unit is not
obstructed.
•
Ensure this unit is well ventilated.
"TRK FULL"
•
The number of files has exceeded the supported limit.
"USB A NO DEVICE"
"USB B NO DEVICE"
•
The USB device is not connected. Examine the connection.
"USB OVER CURRENT ERROR"
•
The USB device is using too much power. Disconnect the
USB device, switch off the system and then switch on
again.
"VBR"
•
The system cannot show the remaining play time for
variable bit rate (VBR) tracks.
Remote control code
When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
Preparation
Press [CD/RADIO/AUX] to select "AUX 1" or "AUX 2".
█
To set the code to "REMOTE 2"
1
Press and hold [CD/RADIO/AUX] on the main unit
and [2] on the remote control until "REMOTE 2" is
shown.
2
Press and hold [OK] and [2] for a minimum of
4 seconds.
█
To set the code to "REMOTE 1"
1
Press and hold [CD/RADIO/AUX] on the main unit
and [1] on the remote control until "REMOTE 1" is
shown.
2
Press and hold [OK] and [1] for a minimum of
4 seconds.
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Disconnect the AC power supply cord.
2
While you press and hold [1] on the main unit,
connect the AC power supply cord again.
Continue to press and hold the button until
"– – – – – – – – –" is shown.
3
Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.

Specifications

█
Amplifier section
RMS output power stereo mode
SC-MAX9000
500 W per channel (3 Ω), 1 kHz, 30% THD
High Ch
500 W per channel (3 Ω), 1 kHz, 30% THD
Mid Ch
Low Ch 1000 W per channel (5 Ω), 100 Hz, 30% THD
Total RMS stereo mode power
SC-MAX7000
350 W per channel (3 Ω), 1 kHz, 30% THD
Front Ch
350 W per channel (3 Ω), 1 kHz, 30% THD
Front Ch
Subwoofer Ch
Total RMS stereo mode power
SC-MAX5000
350 W per channel (3 Ω), 1 kHz, 30% THD
High Ch
350 W per channel (3 Ω), 1 kHz, 30% THD
Mid Ch
500 W per channel (2 Ω), 100 Hz, 30% THD
Low Ch
Total RMS stereo mode power
█
Tuner section
SC-MAX9000 SC-MAX7000
Frequency modulation (FM)
Preset memory
Frequency range
87.50 MHz to 108.00 MHz (50 kHz step)
Antenna terminals
Amplitude modulation (AM)
Preset memory
Frequency range 522 kHz to 1629 kHz (9 kHz step)
520 kHz to 1630 kHz (10 kHz step)
SC-MAX5000
Frequency modulation (FM)
Preset memory
Frequency range
For South America
87.50 MHz to 108.00 MHz (50 kHz step)
For Central America and the Caribbean
87.5 MHz to 108.0 MHz (100 kHz step)
87.9 MHz to 107.9 MHz (200 kHz step)
Antenna terminals
Amplitude modulation (AM)
Preset memory
Frequency range
522 kHz to 1629 kHz (9 kHz step)
For South America
520 kHz to 1630 kHz (10 kHz step)
For Central America and the Caribbean
520 kHz to 1710 kHz (10 kHz step)
█
Disc section
Disc played (8 cm or 12 cm)
MPEG-1 Layer 3, MPEG-2 Layer 3
Pick up
Wavelength
800 W per channel (6 Ω), 100 Hz,
30% THD
30 stations
75 Ω (unbalanced)
15 stations
30 stations
75 Ω (unbalanced)
15 stations
CD, CD-R/RW (CD-DA, MP3 )
790 nm (CD)
4000 W
3000 W
2400 W
21