Sprayer Setup - Graco 258870 Manual

Setup

Sprayer Setup

This sprayer arrives from the factory with a small
amount of test material in the system. It is important
that you flush this material or any storage fluid from
the sprayer before using it.
1. Plug sprayer into a properly-grounded outlet.
2. Fill material cup with water and thread onto sprayer.
ti14992a
3. Put control lever to UP position, then hold trigger in
for 10 seconds.
4. Put control lever DOWN to spray position.
5. Reverse spray tip to UNCLOG position and trigger
sprayer into a waste area.
ti14991a
3A0159A
ti14999a
ti15425a
ti15491a
6. Engage trigger lock and put control lever UP to
release pressure.
ti14994a
7. Unscrew and remove material cup.
8. Disengage trigger lock, put control lever DOWN,
hold sprayer slightly above material cup, and pull
trigger to discharge fluid from pump.
9. Discard material in the cup.
ti14999a
ti15478a
11