Table of Contents
Advertisement
Figure 30. DediProg SF600 Connected to the Mohon Peak CRB
B.4
Programming
With the SF600 programmer connected as described in
power supply in and turn the power supply on.
Do not push the power button on the CRB, or the front panel of the chassis (SPI Flash must be
programmed with standby power from the system power supply, but without the CRB actually
running.)
Start the DediProg Engineering software by double-clicking the desktop icon on the PC.
Figure 31.
DediProg SF600 Engineering Desktop Icon
82
BIOS Update Using an SPI Programmer
Section
B.3, plug the system (ATX)
Getting Started Guide
Advertisement
Table of Contents
