Table of Contents
Advertisement
1. MOUNTING
3. Set the F Mount Panel to the TZT9F unit, then using the hex bolts attached to
TZT9F, fix the F Mount Panel to the unit.
Frontmount panel
4. Connect necessary cable, referring to chapter 2.
5. Set the unit and F Mount Panel into the cutout as shown in the below figure, then
use the supplied self-tapping screws (5×20 SUS304 × 4 pcs.), to fix the F Mount
Panel to the console.
Note: Be careful not to pinch the cables connected at step 4.
Self-tapping screws
(SUS304)
Note: Where the mounting location may be exposed to water (spray or splash),
apply a bead of marine sealant around the rear of the F Mount Panel, for water-
proofing, before setting the F Mount Panel and unit into the cutout. Wipe the area
clean to remove any marine sealant residue and allow time for the marine sealant
to dry.
1-6
Hex bolt
TZT unit
TZT unit
Hex bolt
Advertisement
Table of Contents
