Table of Contents
Advertisement
3. HOW TO SET UP THE EQUIPMENT
Menu item
[Low Frequency]
[Transducer Power LF]
[Band Width (LF)]
When [Transducer Setup Type] is set to [Manual] and connected to DFF3-UHD
Menu item
[TX Volt HF]
Set the TX voltage (V) of the transducer connected to the high frequency side.
[TX Volt LF]
Set the TX voltage (V) of the transducer connected to the low frequency side.
[High Frequency]
Set the frequency (kHz) of the transducer connected to the high frequency side.
[Low Frequency]
Set the frequency (kHz) of the transducer connected to the low frequency side.
Motion sensor menu
The [Motion Sensor] menu sets up the motion sensor, which provides for stable dis-
play of the seabed, schools of fish, etc. in moderate-to-rough seas.
Note 1: For connection of NMEA0183 equipment, ask your FURUNO dealer to set up
the motion sensor.
Note 2: To use the heaving function, the following settings are required at the satellite
compass. For the setting procedure, see the operator's manual for your satellite com-
pass. Settings for SC-30 are done from the [IF-NMEASC] menu, settings for SC-50/
110 are done from the [DATA OUT] menu.
Sentence
Baud rate
Cycle
PGN
The [MOTION SENSOR] menu appears in the [Transducer Setup] menu when the
[Heaving Correction] is activated in the [Fish Finder] menu. If the satellite compass
SC-30 or SC50/110 is connected, set the distance between the antenna unit (or sen-
sor) of the satellite compass and transducer (high and low if connected) here.
SC-30/33/50/70/110/130
3-20
Set the kHz frequency for low frequency. Setting ranges vary
depending on the transducer connected.
Note: Shown with connection of internal fish finder, DFF1,
BBDS1, DFF3, DFF1-UHD.
Set the transmission power for low frequency.
Note 1: Shown with connection of internal fish
finder, DFF1, BBDS1.
Note 2: For DFF1-UHD users, when the con-
nected transducer TDID is not supported by the
DFF1-UHD, the setting is fixed as [1000].
Set the bandwidth for low frequency.
Note: Shown with connection of DFF3.
ATT, HVE
38400BPS
25ms
HF Transducer
HF Transducer
Up/Down
Up/Down
LF Transducer
LF Transducer
Description
Description
NMEA0183
Heave: 65280
Attitude: 127257
Bow/Stern for HF
Bow/Stern for HF
Port/Starboard for HF
Port/Starboard for HF
Port/Starboard for LF
Port/Starboard for LF
Bow/Stern for LF
Bow/Stern for LF
Options
(setting range)
[600], [1000]
CANbus
Advertisement
Table of Contents
