Furuno TZT9F Installation Manual page 12

1. MOUNTING
5. Connect all cables at the back of the TZT9F. (See section 2.1)
6. Attach flush mount sponges to the bezel of TZT9F.
7. Set TZT9F to the cutout made at step 3.
8. Attach the flush mount fixture to the TZT9F with hex bolts.
① ①
1-4
Flush mount sponge 9H (2 pcs.)
Unit (Rear Side)
Attach the flush mounting Attach the flush mounting
plate to the TZT9F. plate to the TZT9F.
Flush mount sponge 9V (2 pcs.)
② ② Set TZT9F to the cutout.
Peel off the release paper.
Attach mount sponge on
the highlighted area.