Table of Contents
Advertisement
1. MOUNTING
1.1.1
Desktop mounting
Your TZT9F is shipped with a bracket for desktop mounting. The following procedure
shows how to install the unit on a desktop.
1. Place the unit face-down on a soft/clean surface, then unfasten the knob bolts on
either side of the unit.
Knob bolt
2. Separate the hanger from the unit. If the hanger does not release easily, gently
move the arms of the hanger outwards as you separate it from the unit.
3. Fix the hanger to the installation location by using the supplied self-tapping screws
(5×20 SUS304). The screw locations are indicated in the figure below.
4. Fit the knob bolts as shown in the figure below, leaving a gap of 10 to 13 mm.
Knob
5. Set the TZT9F unit to the hanger and tighten the knob bolts.
1-2
Hanger
Knob bolt
Knob
Advertisement
Table of Contents
