Table of Contents
Advertisement
PERFORMANCE DATA
Model Name:
PENTAIR IntelliWater Softener
Rated Service Flow - gpm
with an upper collector
Pressure Drop at Rated Service Flow
Rated Capacity
(grains @ lbs. of salt)
Rated Efficiency
(grains/lb. salt @ lbs. of salt)
Maximum Flow Rate During
Regeneration (gpm)
Resin Volume - ft
3
Resin Type - 8% strong acid cation
Tank size
Backwash
Brine Draw and Slow Rinse
@ lb of Salt
Rapid Rinse
Fill @ lb of Salt
Operating Pressure:20 -125 psi or 1.4 – 8.8 kg/Centimeter
These water softener systems have been tested by WQA and conform to NSF/ANSI 44 for specific performance claims as verified and
substantiated by test data. The rated salt efficiencies above were also determined in accordance with NSF/ANSI 44 and are only valid at
the salt dosage referenced above. An efficiency rated water softener is a demand initiated regeneration (DIR) softener which also complies
with specific performance specifications intended to minimize the amount of regenerant brine and water used in its operation. Efficiency
rated water softeners shall have a rated salt efficiency of not less that 3350 grains of total hardness exchanged per pound of salt (based on
NaCl equivalency) (477 grams of total hardness exchanged per kilogram of salt), and shall not deliver more salt than its listed rating. The
rated efficiency of the water softener, the salt dosage at that efficiency, the capacity at that salt dosage and that of the efficiency is only
valid at the stated salt dosage. Efficiency is measured by a laboratory test described in NSF/ANSI 44. The test represents the maximum
possible efficiency the system can achieve. Operational efficiency is the actual efficiency achieved after the system has been installed. It
is typically less than the efficiency due to individual application factors including water hardness, water usage, and other contaminants that
reduce the water softener' s capacity. These systems are not intended to be used for treating water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system. Refer to the system Installation and
Contact your local dealer for parts and service. See your owner' s manual for warranty information.
30 • PENTAIR INTELLIWATER CONNECTED WATER SOFTENER
PNR-POE1-XTR3-01
10
10.2
18,000 @ 3.75
29,500 @ 9.0
34,000 @ 15.0
4,870 @ 3.75
2.4
1
10" x 44"
8
35 @ 3.75
45 @ 9.0
56 @ 15.0
6
5 @ 3.75
12 @ 9.0
20 @ 15.0
Acceptable Salt Type: Sodium Chloride
All Systems above tested at 35psi +/- 5 psi, pH of 7.5 +/- 0.5,
Capacity Testing Flow Rate = 50% of the rated service flow rate for the various size systems
Service Manuals for set-up and programming instructions.
Pentair Residential Filtration, LLC
13845 Bishops Drive Suite 200
Brookfield, Wisconsin 53005
PHONE: (262)-238-4400
PNR-POE1-XTR3-02
10
13
27,000 @ 5.6
44,250 @ 13.5
51,000 @ 22.5
4,870 @ 5.6
2.4
1.5
10" x 54"
8
54 @ 5.6
70 @ 13.5
87 @ 22.5
6
8 @ 5.6
18 @ 13.5
30 @ 22.5
, Operating Temperature: 34 - 110° F or 1.1 – 43.3° C
2
PNR-POE1-XTR3-03
12
14
36,000 @ 7.5
59,000 @ 18.0
68,000 @ 30.0
4,870 @ 7.5
3.5
2
12" x 52"
8
70 @ 7.5
91 @ 18.0
115 @ 30.0
5
10 @ 7.5
24 @ 18.0
40 @ 30.0
C
US
Tested and Certified
by the WQA to NSF/
ANSI Standard 44
and 372 for softener
performance and lead
free compliance and
CSA B483.1
Advertisement
Table of Contents
