Device Settings - ZyXEL Communications PLA6457 User Manual

G.hn wave 2 powerline pass-through gigabit ethernet adapter
Hide thumbs Also See for PLA6457:
Table of Contents

Advertisement

Table 8 Ethernet Screen (continued)
L ABEL
Duplex
Interface Type
Mode
Internal PHY
Link
Powersaving
Inactivity
detection mode
Inactivity time(s)
3.6 De vic e Se tting s
Use the
De vic e
for accessing the Web Configurator.
This screen also lets you upload new firmware to your PLA. You can download new firmware releases
from your nearest Zyxel FTP site (or www.zyxel.com) to upgrade your device's performance. The upload
process uses HTTP (Hypertext Transfer Protocol) and may take up to 2 minutes. After a successful upload,
the PLA will reset.
Chapter 3 Web Configurator
DESC RIPT IO N
This shows the duplex setting (Full or Half). Half duplex cannot send and receive at the same
time. Full duplex can send and receive at the same time.
MII (Media Independent Interface) is the interface between the media access control (MAC)
and the PLA.
(Reduced Gigabit Media Independent Interface) is displayed for the PLA that connects
RG MII
to a device requiring Internet over Powerline, such as a computer.
(Serial Gigabit Media Independent Interface) is displayed for the PLA that connects to a
SG MII
device for Internet access, such as a router.
This shows MAC.
This is the Ethernet's internal physical layer and will always show
This shows
when the PLA has an active connection with a router or computer. Otherwise, it
YES
will show
.
No
Select
to have the selected PLAs go into standby mode when there is no Ethernet
ET H link
connection.
Select
to have the selected PLAs go into standby mode when there is no Ethernet
ET H a c tivity
activity detected.
Otherwise, select
Disa b le d
.
Disa b le d
Set the period of time (5 to 86,400 seconds) when the PLA will go into standby mode when no
Ethernet connection or activity is detected (based on your selection in the
field).
m o de
This field is not available if you select
screen to view basic system information of the PLA. You can also change the password
PLA6457 User's Guide
to have the PLAs never go into standby mode. The default setting is
in the
Disa b le d
Ina c tivity de te c tio n m o de
23
.
No
Ina c tivity de te c tio n
field.

Advertisement

Table of Contents
loading

Table of Contents