Table of Contents
Advertisement
2
Under
IPv4 C o nfig ura tio n
static IP. You can now use this IP address as the default IP address to log into the PLA's Web
Configurator.
Note: The static IP must be in the same subnet of the router.
5.3 Po we rline Pro b le m s
The signal on my G.hn Network is weak.
1
Your PLAs cannot be connected to extension cords. Connect them to standard power outlets.
2
Your PLAs may be located close to large appliances such as refrigerators or air-conditioners that cause
interference with the Powerline signal. Move the adapters further away from such appliances to reduce
interference.
3
Your PLAs may be placed close to electrical devices such as electrical insect-killers which produce radio
waves. These may interfere with the Powerline signals. Move the adapters further away from such
electrical devices.
4
Your wiring may be old and/or low quality or with a long wiring path.
5.4 ENC RYPT Butto n Pro b le m s
The Power light does not blink when I press the
• Check that the device is on.
• Press the
• For PLA, you cannot use the
computer or router, then try again.
The Power lights on both devices blink when I press the ENCRYPT buttons, but the Powerline light
does not turn on.
• Ensure you have pressed the
• Wait for about a minute while the devices set up a connection.
• If that does not work, try again with both devices connected to a power strip next to each other. If
they now connect, then the devices were not on the same electrical circuit before.
Chapter 5 Troubleshooting
, disable
DHC P e na b le
button again, making certain you have pressed the button for 2 to 5 seconds.
ENC RYPT
ENC RYPT
ENC RYPT
PLA6457 User's Guide
and then assign an IP in the
button.
ENC RYPT
button when it is in standby mode. Connect the PLA to a
buttons on both devices.
36
field as the
IPv4 a ddre ss
Advertisement
Table of Contents
