Reset A Nd Enc Rypt Butto Ns; Encrypt Button; Adding Devices To A G.hn Network - ZyXEL Communications PLA6457 User Manual

RESET a nd ENC RYPT Butto ns

2.1 ENC RYPT Butto n
The
ENC RYPT
which also support the ENCRYPT feature. No other Powerline setting changes are required to connect.
The following table summarizes the actions that occur when the
lengths of time.
Table 4 ENCRYPT
T IME
2 to 5
seconds
Note: The domain name is unknown when you use the
2.2 Adding De vic e s to a G .hn Ne two rk
You can connect a number of PLAs on a G.hn Network, but you can use the
two PLAs at a time.
Place a PLA close to another PLA so you have time to set up each one. After you set up the first PLA, you
have 120 seconds to set up the second PLA.
Note: Your PLA must be connected to a networking equipment for the
work. Refer to
Follow the steps below to set up your G.hn Network:
1
Press the
ENC RYPT
blink as the PLA tries to set up a connection with a new random domain name.
button allows you to set up a secure Powerline connection with other G.hn compliant PLAs
AC T IO N
Join an existing G.hn Network
by sharing the same network
name as other devices on the
network.
Section 1.3 on page 9
button at the side of your PLA for 2 to 5 seconds. The encrypted pairing (
PLA6457 User's Guide
C
HA PTER
ENC RYPT
ENC RYPT ED PAIRING L IG HT
BEHAVIO R
The Encrypted Pairing (
light blinks until the device is
connected. This may take a
minute.
ENC RYPT
for more details.
12
button is pressed for specific
PO WERL INE L IG HT BEHAVIO R
) The Powerline ( ) light turns
on if your device is connected to
another PLA or a G.hn Network.
button.
button on only
ENC RYPT
button to
ENC RYPT
2
) light will