HYOSUNG GV125S Owner's Manual page 87

⊙ INSPECTION OF LAMPS
●
Check
lamp, meter lamp, tail
lamp and license plate
lamp work well when the
ignition switch was turned to
the ― ‖ position.
Check if the head lamp
work well when starting the
engine.
●
Check if the brake lamp
work well when the front
brake lever or rear brake
pedal was operated after the
ignition switch was turned to
the " " position.
●
Check if the turn signal
lamp work well when the
turn signal
operated after the ignition
switch was turned to the " "
position.
●
Check if the head lamp,
tail lamp,
lamp and brake lamp are
dusty or dam aged.
if the position
switch
turn signal
The position lamp, meter
lamp, tail lamp and license
plate
motorcycle alw ays comes
on when the ignition switch
is turned to the "
The head lamp is always lit
when starting the engine.
⊙ REPLACEMENT OF THE
LAMP
Requirement electric power
of the lamp shown in the
following chart. When replace
the damaged lamp, always
use the equal capacity.
The use of a lamp other than
was
specification
electric system or the lamp to
damage.
NAMES
Head
lamp
Brake / Tail lamp
Turn signal lamp
License plate
lamp
※ LED :
— 84 —
lamp on
" position.
may cause
CAPACITY
12V - H4 :
HI / LO
60 / 55W × 1
Position
12V - W5W × 1
LED type
12V - R10W × 4
12V – LED
Light Emitting Diode
this
the
type