Replacing only one of the
two
brake
hazardous.
Replacing only one brake
pads can result in uneven
braking action.
Replace both pads together.
After replaced the front or
rear brake pads, squeeze /
depress and release several
times the brake lever/ pedal
so that it is setting at the
original place.
Then, check that the brakes
are operating correctly.
⊙ BRAKE DISK
INSPECTION
Check the brake disk for
damage or cracks.
⊙ FRONT BRAKE FLUID
SUPPLY
1. Place the motorcycle on a
level surface and keep the
handlebars straight.
2. Clean the front brake fluid
reservoir around not to
pads
can
be
allow dust to get inside of it.
3. Loosen the screws and
open the cap.
4. Replenish with brake fluid
to the upper line.
The recommended
brake fluid : DOT4
● Don't
brake fluid over the limit
line. It will leak out of the
brake fluid reservoir.
● Be careful not to allow
dusts or water to go inside
when it is replenished.
● Prohibit the use of non
recommended brake fluid
● Brake fluid can damage
severely the plastics or
rubbers. When it is spilt on
the parts, wipe them up
immediately.
5. Fasten the cap.
⊙ REAR BRAKE FLUID
SUPPLY
— 77 —
N O T E
replenish
with