HYOSUNG GV125S Owner's Manual page 45

● Release
switch immediately after
the motorcycle
started.
● Avoid
starter switch when the
engine is running, or the
starting motor damage.
● Do
not
starting motor for more
than five seconds at a
time as it may over- heat
the wiring harness and
starting motor.
If the engine does not
start after
attempts, check the fuel
supply
system.
The position lamp, meter
lamp, tail lamp and license
plate lamp
motorcycle alw ays comes
on when the ignition switch
is turned to
position.
The head lamp is always lit
when starting the engine.
the starter
has
pressing the
engage the
several
and ignition
on this
"
the
Push the starter switch to start
the engine after the needle of
the speedometer turn back to
the rest position.
The engine warning lamp "
① comes on when the ignition
switch is set to "
the engine stopped as a test of
engine system operation.
As soon as the engine starts,
this lamp should go out.
If the engine system fails, the
yell o w
l a m p "
remains on.
"
— 42 —
" position with
e n g i n e w a r n i n g
" ① comes on and
"