HYOSUNG GV125S Owner's Manual page 28

①
STARTER SWITCH
Use this switch to operate
the starting motor.
With the ignition switch in the
" " position, the engine stop
switch in the "
the transmission is in neutral,
squeeze the clutch lever and
the side stand up and push the
starter switch to start the
engine.
When the ignition switch is set
to " " position with the
engine stopped, the meter
lamp will come on and the
needle of the speedometer will
turn once to the end as a test of
electric system operation.
Push the starter switch after
the needle of the speedometer
turn back to the rest position.
 Release the starter switch
immediately
motorcycle has started.
 Do not engage the starting
motor for more than five
seconds at a time as it may
over- heat the wiring harness
and starting motor.
If the engine does not start
after several attempts, check
the fuel supply and ignition
system.
" "
" position, and
after the
— 25 —
Do not attempt to start the
engine until the needle of the
speedometer completes a full
sweep and returns to the rest
position otherwise the engine
will start badly.
If the engine does not start
or runs badly,
ignition switch to the "
position. After 8 seconds,
turn the ignition switch on,
allow the speedometer needle
to complete its sweep and
return to the rest position
and then attempt to restart.
This allows the ISC (Idling
Speed Control) solenoid to
be initialized.
The position lamp, meter
lamp, tail lamp and license
plate lamp
motorcycle alw ays comes
on when the ignition switch
is turned to
position .
The head lamp is always lit
when starting the engine.
turn the
"
on this
" "
the