HYOSUNG GV125S Owner's Manual page 74

4
3 2
20 ~ 30 mm (0.79 ~ 1.18 in)
1. Place the motorcycle on
the center stard.
2. Loosen the rear axle nut ①.
3. Loosen the drive chain
adjuster lock nuts ②, right
and left.
5
1
5 4
2 3
4. Adjust the slack in the drive
chain by the chain adjuster
④, right and
turning the drive chain
adjusting
clockwise
counter-clockwise.
5. For alignment of the front
wheel and rear wheel,
there are refer
⑤ on the same position,
right and left.
Aligning and adjusting the
slack in the drive chain to 20 ~
30 mm (0.79 ~ 1.18 in),
retighten the right and left drive
chain adjuster lock nut ② and
the rear axle nut① securely
and perform a final inspection.
The drive chain for this
motor- cycle is made of the
special material.
The
replaced with a
motorcycle.
Use of another chain may
lead to premature chain failure.
— 71 —
left,
nut
ence mark
chain should
428HO
as
③
or
be
for