HYOSUNG GV125S Owner's Manual page 64

Never invert
cables. Ensure that the ignition
switch is in position "
before connecting
disconnecting
otherwise some components
might damage.
⊙ CHECK AND CLEAN OF
BATTERY TERMINAL
Clean the battery terminal
when it is dusty or rusted.
Set the ignition switch ―
1.
position.
2.
Remove the seat.
3.
Check the battery lead wire
and terminal.
4.
If necessary : disconnect the
negative ⊖ battery wire first,
then disconnect the positive
⊕ battery wire.
5.
Remove the battery.
6.
Clean the terminal.
7.
If there is white dust, clean it
with warm water.
8.
Connect the battery wires
and grease the terminal
lightly.
the battery
"
or
the battery,
‖
— 61 —
When
battery, be sure to connect
the positive ⊕ battery wire
first, then
negative ⊖ battery wire.
Make sure to initialize ECU as
following when remounting the
battery due to change the
battery.
To initialize ECU, turn the
ignition switch on and off
alternately five times for 2
seconds.
⊙ BATTERY INSTALLATION
The battery installation need
particular attention to following
points :
1. Remove the seat.
Install the ⊕ positive terminal
2.
of the battery to face the
right side of the motorcycle
reinstalling
connect
the
the