Switching The Projector On - Barco SP2K-S Installation Manual

Projector Power Cycle

8.2 Switching the projector ON

Possible ways to switch on
There are multiple ways to switch on the projector, depending on a few factors:
Current
How to power on
Power Stage
OFF
•
•
ECO mode
•
•
•
How to switch on locally, using the touch display?
1. Ensure that the SP2K-S projector is installed onto a stable platform.
2. Ensure the projector is correctly connected to the mains power.
3. Ensure that the correct lens is installed for your application.
4. Press the power button to switch the projector ON.
The projector will start up and the touch display will start its initialization procedure.
5. Wait until the Projector control menu is fully accessible on the touch display.
Tip: While the menu may become accessible early on, certain icons (e.g. the Light button) may
be greyed out until the projector is ready to play.
Image 8–4 Example of the Projector control menu on the touch display.
6. Press the Light button to activate the light source. Use a press of >1 second.
The Light source will prepare itself for playing, by doing a laser self-test. This may take a while, depending
on your projector variant. While the light source is turning on, the Light button will blink green. Once
completed it will be full green.
7. Press the Dowser button to open the dowser.
5. Only possible if the Touch Display option has been chosen.
96 R5913197 /02 SP2K-S
Locally, using the power button
Remotely, using GPI3
Locally, using the power button and touch
display 5
Remotely, using Web Communicator
Remotely, using GPI3
Notes
After the projector is powered, you can
further access the projector using either Web
Communicator or the optional touch display.
Take into account that the Web
Communicator method can only be used
when the projector is in ECO mode.