Switching On The Projector - Barco R9040040 Instruction Manual

AC Power connections

Switching on the projector

Switching on
OFF ON
POWER MAINS
REMOTE
image 5.3
Power switch
Switching off
Start up in operational mode
PROJECTOR WARM UP
A FULL WHITE PATTERN WILL BE
GENERATED FOR x MIN.
FOR IMMEDIATE USE OF THE
PROJCTOR, PRESS <EXIT>
WARNING : SKIPPING THIS
PROCEDURE CAN REDUCE THE
INITIAL PICTURE QUALITY OF THE
PROJECTED IMAGE;
YOU CAN ADJUST THE IMAGE
DIMENSTIONS WITH THE ARROW
KEYS TO AVOID SCANNING ON
THE EDGES OF THE CRT'S;
THIS OPTION CAN BE DISABLED IN
THE SERVICE MENU
with <ENTER>
<EXIT> to return
menu 1
ENTER
EXIT
EXIT
800 periphals
COMM. PORT PORT 3
IR RS 232 OUT RS 232 IN
EXIT
See installation instructions before connecting to the supply.
Voir la notice d' installation avont de raccorder au réseau.
R G B
Comp / H-Sync V-Sync
PORT 4 / 5
This device complies with part 15 of the FCC rules.
Operation is subject to following two conditions (1).
This device may not cause harmful interference,
and (2) this device must accept any interference that
may cause undesired operation.
VIDEO
S - VIDEO
OFF - ON
75 Ohm
PORT 2 PORT 1
OFF - ON
75 Ohm
green: operation
red: standby
PROJECTOR MODE