Table of Contents
Advertisement
8. STARTING UP
About this chapter
This chapter contains the switch ON and switch OFF procedures of the DPxK-32B. These procedures enumerate all the important
points which have to be checked prior to switching ON the projector. This is to ensure a safe start up of the projector.
Overview
•
Switching ON the DPxK-32B digital projector
•
Switching OFF the DPxK-32B digital projector
8.1
Switching ON the DPxK-32B digital projector
How to switch on
1. Make sure that the DPxK-32B projector is installed upon a stable pedestal. See chapter "Positioning the DPxK-32B at port
window", page 15.
2. Make sure that the exhaust system is properly installed. See chapter "Installation of the exhaust system", page 17.
3. Make sure that the right lens is installed for your application. See chapter "Lens selection", page 49.
4. Make sure that the lamp and lamp house are correctly installed. See chapter "Lamp & Lamp House", page 25.
5. Make sure the projector is correctly connected to the power net. See chapter "Connecting the DPxK-32B with the power net",
page 21.
6. Check if a video source is connected with the projector. See chapter "Source input ports of the DPxK-32B", page 62.
7. Check if the communicator touch panel is installed. See chapter "Communicator Touch Panel", page 65..
8. Press the power switch to switch ON the projector. As a result the projector starts up in standby. So, the lamp is OFF and the
dowser closed. No internal pattern is selected. The communicator touch panel starts its initialization procedure.
-
When '0' is visible, the projector is switched OFF.
-
When '1' is visible, the projector is switched ON.
9. Press the STANDBY button on the local keypad or use the Communicator Touch Panel to activate the lamp.
10.Press the DOWSER button on the local keypad or use the Communicator Touch Panel to open the dowser. As a result the applied
source will be displayed.
C
AUTION
When for any reason a restart of the projector is required, the content server should be restarted also.
8.2
Switching OFF the DPxK-32B digital projector
How to switch OFF the DPxK-32B digital projector?
1. Press the standby button on the local keypad or use the Communicator Touch Panel to switch the projector from operation to
standby. As a result the lamp turns off but the fans remain turning to cool down the projector.
2. Let the projector cool down at least 5 minutes or until the speed of the fans decreases.
3. Switch OFF the projector with the power switch.
R59770491 DPXK-32B 17/09/2012
:
See user's guide of the Communicator Touch Panel to operate and control the DPxK-32B.
8. Starting up
69
Advertisement
Table of Contents
