Switching On The Projector - Barco BARCOREALITY 908 Installation Manual

5. AC Power
For continued protection against fire hazard: replace with the same type of fuse and refer replacement to
qualified service personnel.

5.3 Switching on the projector

How to switch on the projector?
1. Press the mains ON/OFF switch to switch on the projector.
Pressed
Not Pressed
Table 5-1
Mains Power Switch
See image 5-3.
The Stand by indication lamp will show the status of the projector:
No light up
Green color
Red color
Table 5-2
Status lamp
Image 5-3
Power switch
The switching on modes
When switching on with the power switch, the projector can start in 2 different modes depending on the "Power Up" setting in the
Service mode:
• Operational mode (Picture displayed).
• Stand By mode.
Starting up in Operational Mode
The projector can start up with the selected source or the projector can start up with a warm up cycle message.
PROJECTOR WARM UP
A FULL WHITE PATTERN WILL BE
GENERATED FOR x MIN.
FOR IMMEDIATE USE OF THE
PROJECTOR, PRESS <EXIT>
WARNING: SKIPPING THIS
PROCEDURE CAN REDUCE THE
INITIAL PICTURE QUALITY OF THE
PROJECTED IMAGE;
YOU CAN ADJUST THE IMAGE
DIMENSIONS WITH THE ARROW
KEYS TO AVOID SCANNING ON
THE EDGES OF THE CRT'S;
THIS OPTION CAN BE DISABLED IN
THE SERVICE MENU
with <ENTER>
<EXIT> to return
Menu 5-1
When this warm up cycle message appears on the screen, the menu offers the possibility to start with a x minutes taking warm up
period (press ENTER) or to skip this cycle (press EXIT). The x minutes and the horizontal frequency can be programmed in the
'Service mode' under the item 'Projector Set Up'.
32
Switched OFF
Operational mode
Stand By mode
R5976354 BARCOREALITY 908 SPLIT PACK 10092002
ON
OFF