Rock Embers (Optional) - Travis Industries 616 Mod-Fyre GSR2 Owner's Manual

58
Optional Equipment
Embers and EG Glass (Optional)

Do not allow the glass or rock material to block the air slots or to become too thick (maximum 1
layer deep on the burner). Failure to properly install the Rock Ember material may lead to
sooting and poor performance.

Make sure the gas control valve is OFF and the heater is cool prior to conducting service.

If using propane (LP), convert the appliance before installing the media

This appliance requires the use of a fireback kit. Install the Fireback BEFORE installing the
media.
Overview
This kit comes with ember glass (4lbs) and (2) sizes of ember material (1/2 lb. of small rocks and 4lbs of
large rocks).
Amount of Ember Rock Needed:

Ember-Glo Glass - 4 lbs. (approximately 4 cups).

Small Rock - 1/2 lbs. (approximately 1-1/4 cups).

Large Rock - 4 lbs. (approximately 11 cups).
Installation Notes

Discard rock at the bottom of the bag that has disintegrated (turned to small, sand-like material).

Put down the EG glass first. Cover the entire media tray with EG Glass (Do not cover the burner).

Put down the large rock next. Cover the EG glass with large rock.
NOTE: Do not place large rocks over any burner ports (This will cause sooting).

Place one layer of small Ember Rock over the burners.

Do not stack media in piles that may fall over or block airflow.
© Travis Industries
(for qualified installers only)
WARNINGS
1/10/2022 - 1559 616 MF GSR2