Vent Attachment - Tight Installations - Travis Industries 616 Mod-Fyre GSR2 Owner's Manual

Installation (for qualified installers only)
Vent Attachment – Tight Installations
The vent connector is shipped attached to the insert but must be removed to facilitate tight
installations. See the directions below for installation.
1. Locate the screw in the top center of the front of the insert. Use a ¼" nut driver to remove the screw
and slide the connector toward the back of the insert to disengage the connector from the top of the
insert.
2. Stretch the liners to their full length. Attach the flex liners to the cap (secure with screws). Route the
flex vent through the chimney from above.
© Travis Industries 1/10/2022 - 1559
19
616 MF GSR2